- V3 board profile defaults to DIO flash mode (QIO fails on some flash chips)
- flash.py: auto-verify on --erase/--full, post-flash boot monitoring with
auto-DIO retry on bootloop detection
- flash.py: erase keeps device in download mode (--after no_reset) to prevent
race condition on re-entry
- flash.py: remove --dio/--verify flags (now automatic), hidden --flash-mode
for power users
- RNode_Firmware.ino: release BT memory (~70KB) on V3 boundary where BT is
compile-time disabled
- RNode_Firmware.ino: add WDT resets throughout setup() to prevent timeout
during long init sequences
- RNode_Firmware.ino: fix while-not-Serial blocking on V3 (no USB-CDC)
- RNode_Firmware.ino: init bt_devname from WiFi MAC when BT disabled
- RNode_Firmware.ino: bootloop detection via RTC_NOINIT_ATTR -- forces config
portal after 5 rapid reboots
MODE_ACCESS_POINT unconditionally blocks announce broadcasts in
Transport::outbound(), preventing local TCP clients from discovering
each other. Changing to MODE_GATEWAY allows announces to flow through
send_outgoing() which broadcasts to all connected clients.
Root cause: receiver's announce was stored in announce_table but never
rebroadcast on LocalTcpInterface, so sender could never find a path.
