RNode Flasher
Developed by Liam Cottle
1. Select your device
Product
Model
Can't find your device? Open an issue on GitHub
2. Select firmware to flash (.zip)
Flashing: {{flashingProgress}}% Flashing: please wait...
Download Firmware : {{ recommendedFirmwareFilename }}
Official Firmware • CE Firmware • Transport Node Firmware
Common error messages
• Hardware Failure: You need to provision the eeprom in step 3.
• Firmware Corrupt: You need to set the firmware hash in step 4.
3. Provision EEPROM (sets device info, checksum and blank signature)
Provisioning: please wait...
4. Set Firmware Hash (uses hash from board, will fix later)
Setting Firmware Hash: please wait...
5. Done
If you made it this far, and all previous steps were successful, your RNode should be ready to use with MeshChat or Sideband.
Advanced Tools
EEPROM dumps are shown in dev tools console.
Configure TNC Mode (optional)
• TNC mode allows an RNode to be used as a KISS compatible TNC over the Serial Port.
• This mode makes it usable with amateur radio software that can talk to a KISS TNC over a serial port.
• You must leave TNC mode disabled when using RNode with apps like MeshChat or Sideband.
Frequency (Hz)
Bandwidth
Tx Power (dBm)
Spreading Factor
Coding Rate
Configure Bluetooth (optional)
Bluetooth is not supported on all devices. Pairing is untested and may not work!